国产剧情毛片,国产不卡免费视频,国产一区视频在线免费观看,yellow版字幕网

Front view of WLT vacuum VLT-1600B dual-unit coating machine

Top view of VLT vacuum VLT-1600B dual-unit coating machine

Side view of VLT vacuum VLT-1600B dual-unit coating machine

Technical parameter

Device model	VLT-1000B	VLT-1200B	VLT-1400B	VLT-1500B	VLT-1600B	VLT-1800B	VLT-2000B
Size	1000×1500	1200×1650	1400×1800	1500×1850	1600×1950	1800×1950	2000×2100

Power supply type: resistance heating tungsten filament evaporation transformer power supply, high-voltage ion bombardment power supply, thyristor power supply
Structure: vertical double door, air pumping system
Vacuum system: slide valve pump + roots pump + diffusion pump maintenance pump (or optional: cryogenic pump, cryogenic system)
Ultimate vacuum: 6×10-4pa (no load, clean room)
Pumping room: no-load air pumping to 5×10- 2pa less than or equal to 6 minutes
Workpiece rotation: single axis/6 axis/8 axis revolution/inverter stepless speed regulation
Control mode: manual + semi-automatic + fully automatic integration / touch screen + PLC
Remarks: The size of the vacuum chamber can be customized according to customer's product and special process requirements

Equipment characteristics
Production period: -900sec (15 minutes)/1 period shorter than that of similar equipment
Coating method: heating wire evaporation coating method
Coating quality: Each door has 6`8 sets of fixtures, and the coating thickness is uniform at the same time for autobiography and revolution. It is suitable for mass production of economical car lamps. Dehumidification capacity: The vacuum chamber is equipped with an ultra-low temperature freezing system below minus 140 degrees to fully absorb moisture. Vacuum reach speed
Operating cost: The volume of the vacuum chamber is relatively large, the number of coatings is large each time, and the operating cost of a single piece is low
Number of fixtures: According to the size of the product, the fixture can be changed to 6 axis or 8 axis at will, without any installation and adjustment when changing
Floor area: double-door structure, relatively smaller installation area and operation area than similar equipment
Operation method: The man-machine interface can be set and monitored intuitively, and the person who has no management password can not change it
After-sales service: There is an after-sales service center and parts warehouse, which can quickly deal with problems in use

Equipment principle diagram

 

Left: Apply a certain voltage to the heating wire in a suitable vacuum environment to evaporate the aluminum wire placed on the heating wire to the surface of the rotating product to achieve the purpose of aluminum plating.

Right: According to the size of the product, change the 6-axis fixture at will, (when the product size is relatively large, each vacuum chamber is equipped with six fixtures) or 8-axis (when the product size is relatively small, each vacuum chamber is equipped with 8 fixtures), it is not necessary for replacement Any installation and adjustment.